Lot 847-Cracker Box Boat


847(4).JPG
847(1).JPG
847(2).JPG
847(3).JPG
847(4).JPG
847(1).JPG
847(2).JPG
847(3).JPG
847(4).JPG
847(1).JPG
847(2).JPG
847(3).JPG
847(4).JPG
847(1).JPG

Cracker Box Race/Hot Rod Boat

Overall Length 16’ Beam 6’

Glen-L Machine Homemade

Hull Weight 500 Lbs.

Construction: Rib frames, beams and battens service. Planking: 2 layers ¼” Marine grade Mahogany Plywood

6 Oz Fiberglass cloth, 3 coats epoxy resin.

Engine: Indmar marine/Ford 351 c.i With Holley 4 bbl Carb. Borg Warner Velvet Drive Trans. Prop 12”/12” Balanced rudder. Mounted-Bolt on trim tabs.

Cockpit- 2 seater- Marine grade bucked bilge pump, engine vent, horn, 25 gallon gas tank, hot foot throttle control.

This boat is right out the history book from 1957. If you wanted a race or hot rod boat back then you most likely had to build it yourself at home in your garage. This design by Glen L Marine from 1953. Has been updated to accommodate modern small block engines up to approximately 350 c.i.